Minelab F1A4 Manuel de service télécharger pdf (Page 17)

Operations Manual

Page 17

4.4 Battery Pack (see Figure 7)

The F1A4 can be powered by one of two battery packs.

NOTE:

Before connecting or disconnecting either battery pack ensure that the

unit is switched Off on the Control Panel.

4.4.1 Lead-Acid Battery Pack

To use the belt-mounted Lead-Acid battery pack as a power source:

a. It is necessary to undo the –snaplocks“ on the base of the Control

Box and remove the Battery Carrier and Cover.

b. A freshly charged Lead-Acid Battery can then be connected to the

Control Box via its supplied cable to the socket marked POWER

ACCESSORY that is located on the base of the Control Box.

c. The detector can now be switched to Search and operations

resumed.

4.4.2 ’D, Cell Battery Pack

To use the –D“ cell battery pack as a power source:

a. Disconnect the Coil Cable from the Control Box and remove the

Control Box from the Control Box Bag or from the handle as

applicable (see Paragraph 4.2).

b. To gain access to the four –D“ cells it is necessary to release the two

–snaplocks“ that secure the battery cover on the battery carrier which

can be found on the bottom of the Control Box.

c. The cells can now be removed or replaced (using the battery map

inside the battery carrier) in accordance with the illustrations on

page 16 of this manual.

d. The battery cover can now be refitted and the –snaplocks“ engaged.

Connect the Control Box to the handle or insert into the Control Box

Bag. Reconnect the Coil Cable to the Control Box.

e. The detector can now be switched to Search and operations

resumed.

PDF created with FinePrint pdfFactory trial version http://www.fineprint.com

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

Pas de commentaire

Minelab F1A4 Manuel de service Page 17