Minelab F3 Manuel de service télécharger pdf (Page 16)

2.5 Changing Endcaps. The F3 can be used with Black or

Red Sensitivity Endcaps. The decision on which Endcap to use will

be provided by the local authority. To fit a Sensitivity Endcap:

a. Ensure the F3 is switched off.

b. Place the thumb of one hand in the centre of the Endcap and

curl the fingers under the base of the Endcap.

c. Gently push inwards with the thumb and simultaneously pull the

base of the Endcap away from the Electronics Pack (Figure 11).

d. Exchange or replace the Endcap by gently positioning the inside

of the base of the Endcap under the base of the Electronics

Pack. Using the palm of the hand, apply light pressure to fit the

Endcap into position.

Figure 11: Removing a Sensitivity Endcap

**WARNING**

The Sensitivity Endcap also provides impact protection to

the Electronics Pack. Whenever an Endcap has been

removed from the Electronics Pack never

place the base of

the detector against the ground or sharp objects.

P0650-A

P0651-A

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 48 49

Pas de commentaire

Minelab F3 Manuel de service Page 16