Minelab X-Terra 50 Manuel d'instructions télécharger pdf (Page 31)

Press and hold Press once

Custom patterns are saved

when the X-Terra is switched oﬀ .

To erase custom patterns and

return to preset patterns:

Turn the detector oﬀ .

While pressing and holding

PATTERNS, turn the detector back

on, by pressing power once.

During the start up sequence,

release

PATTERNS.

After the start up sequence,

the patterns erased message

(PE) will appear for 3 seconds

to indicate that the current

patterns have been erased and

returned to the preset patterns.

The settings sensitivity, volume,

noise cancel* and ground balance

are saved when the X-Terra is

switched oﬀ . To return to the

preset menu values:

Turn the detector oﬀ .

While pressing and holding

MENU SELECT, turn the detector

back on, by pressing

POWER once.

During the start up sequence,

release

MENU SELECT.

After the start up sequence, the

factory preset message (FP), will

appear for 3 seconds to indicate

that sensitivity, volume, noise

cancel* and ground balance*

have returned to the preset values.

Press and hold Press once

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 39 40

Pas de commentaire

Minelab X-Terra 50 Manuel d'instructions Page 31