Minelab F3 Manuel de service télécharger pdf (Page 23)

4. F3L Configuration

4.1 Introduction. Detectors fitted with the LED Display and

Volume/Sensitivity (V/S) Control leave the factory with the LED

Display and Volume/Sensitivity Control enabled. The LEDs give an

operator a visual indication of the size and proximity of a target. The

V/S Control provides the facility to reduce or increase V/S levels to

suit specific detection circumstances. If required, the LED display

and the ability to vary V/S levels can be disabled on the F3L.

4.2 Description. The F3L is fitted with a modified speaker

pod comprising (Figure 13):

• 13 red LED display to display target strength and proximity

• Volume/Sensitivity increase button and Volume/Sensitivity

decrease button .

• Red “Battery Low” alarm LED.

• Quick guide to enable and disable all LEDs.

• Quick guide to enable and disable V/S control buttons.

Volume/Sensitivity Control buttons

Target Strength LEDs

(13 total)

Target Strength LEDs

(13 total)

“Battery Low”

Alarm LED

Quick guide to

enable and disable

LED Display

Quick Guide to

enable and disable

Volume/Sensitivity

Control buttons

Figure 13: F3L Speaker Pod

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 48 49

Pas de commentaire

Minelab F3 Manuel de service Page 23