Minelab EXPLORER II Manuel de service télécharger pdf (Page 23)

THE MINELAB EXPLORER II

CONNECTING THE SHAFT ASSEMBLY

Figure 2.9 Adjusting the shaft and

angle of the search coil

Figure 2.8 Inserting shaft assembly

into control box

Coil not connected?

These instructions require the

search coil to be connected to the

lower shaft. For directions on this

procedure, refer to page 13.

STEP 5 Secure upper shaft in position by locking the control box

camlock.

STEP 6 (Figure 2.9) Adjust shaft to the desired length and then lock

with shaft camlock lever.

STEP 7 (Figure 2.9) Tilt the search coil to the most comfortable

angle, keeping in mind it will need to be parallel to the

ground during detecting.

NOTE To avoid difficulty securing the control box camlock

lever, ensure the shaft camlock is released to allow greater

shaft movement.

You are now ready to proceed to the handle assembly.

P0599-A

P0598-A

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 34 35

Pas de commentaire

Minelab EXPLORER II Manuel de service Page 23