Minelab EXPLORER II Manuel de service télécharger pdf (Page 28)

THE MINELAB EXPLORER II

www.minelab.com

STEP 4 (Figure 2.15) Gently pull the coil cable from inside the yoke/

lower shaft.

STEP 5 (Figure 2.16). Carefully feed the coil cable of the new coil

back into yoke and lower shaft. Continue to feed the cable

into the shaft unitl the connector is visible at the top of the

shaft.

Note: It may be easier to pull the cable through the lower

shaft using a length of string or cord. Once this is completed

you should be able to see approximately 4 inches (100mm)

of cable between the coil yoke and the search coil. This is

the slack necessary to allow adjustment to the angle of the

search coil.

STEP 6 Re-attach the yoke and the search coil. Be careful not to

damage the thread of the nut by over-tightening. See Figure

2.2 and 2.3.

STEP 7 Reconnect cable to control box (as directed in Connecting

the shaft assembly, page 16).

REPLACING AND FITTING THE SEARCH COIL

Figure 2.16 Removing the coil cable

Pull Coil Cable

up inside of

yoke/shaft

P0613-A

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35

Pas de commentaire

Minelab EXPLORER II Manuel de service Page 28