Minelab F3 Manuel de service télécharger pdf (Page 16)

F3 Field Service Manual

Page 16

Figure 12: Correct Fitting of the Wiring Loom into the Electronics Pack

NOTE

Take great care when connecting the wiring loom plug to the electronics pack. DO NOT

force the connection because this could damage or break the connector on the printed

circuit board.

● Fold excess wiring loom cable into the electronics pack above the plug.

Figure 13: Excess Wiring Loom Cable Folded Correctly & Cable Router

● Refit the bulkhead cover with six screws.

● Route the wiring loom around the cable router on the side of the bulkhead cover.

(Figure 13)

● Refit the sensitivity endcap.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 41 42

Pas de commentaire

Minelab F3 Manuel de service Page 16