Minelab F3 Manuel de service télécharger pdf (Page 38)

F3 Field Service Manual

Page 38

● Holding the detector and lower camlock assembly upside down (to prevent the lower

pressure block falling out) slide the lower camlock assembly fully onto the lower shaft

with a twisting motion.

Figure 54: Attaching Lower Camlock

● Turn the detector back over and ensure that the lower camlock assembly is

positioned on the lower shaft with the cam lever uppermost.

● Refit the other lower camlock pin. (Figure 55)

Figure 55: Connected Lower Camlock

● Refit the friction blocks to the lower camlock body. The flat side of the friction blocks

should face down.

● Connect coil (Section 3.4.b), electronics pack (Section 3.3.b) and wiring loom as

applicable.

1 2 ... 33 34 35 36 37 38 39 40 41 42

Pas de commentaire

Minelab F3 Manuel de service Page 38