Minelab GP 3500 Manuel d'utilisateur télécharger pdf (Page 7)

complete assembly instructions

– continued

page 6

l 2 assembly l

GP 3500

page 6

Securing and connecting the coil cable

NOTE – Always ensure that the control box is turned Off before connecting or

disconnecting the coil, to avoid damage to the detectors electronics.

Step 1.

Wind the coil cable around the shaft and plug the coil connector into

the coil socket on the control box. Check that the cable is wound firmly

around the shaft without strain, leave enough slack at the bottom of the

cable near the coil to allow for adjusting the angle of the coil without

placing strain on the coil cable.

Step 2. Fasten the cable into position using the Velcro straps provided (20).

Step 3. Secure the bungy cord through the bow knuckle (22). Slide the knuckle up

or down the shaft (8) to find the balance point and tighten the wing-nut.

HINT If the coil cable is able to move around, especially near the coil, it will be

‘seen’ by the detector and cause random noises which may be confusing.

Figure 2.4 – Handle and bungy cord

Attaching the Control Box and achieving balance

Step 1. Position the ‘T-section" on top of the control box (10) into the armrest with the

battery plug at the rear. Tighten the nylon wing nuts by hand.

Step 2. Loop the Quick-Trak button cable from the handle, back along the shaft and plug it

into the Smart Point connection in the control box (10). (See page 33)

Step 3. Adjust the shaft length and coil angle for a comfortable position. The lower

fibreglass shaft can be set into position by locating the spring clip into

the holes provided in the upper shaft and hand tightening the

locking nut at the end of the shaft. The correct length of shaft

for your height, is at the point that the coil can be

swung in front without you bending, dropping your

shoulder or work in a position that will

be uncomfortable.

Bow Knuckle (22)

Bungy Cord (21)

Handle with

Wrist Strap (9)

complete assembly instructions

– continued

l 2 assembly l

page 7

GP 3500 GP 3500

www.minelab.com

page 7

Figure 2.5

The GP 3500 battery assembly

Headphones (16) Power Cable to Detector (19)

Backpack Pouch (18)

6Volt Battery (17)

Fitting and connecting the battery pack

Step 1. Fit the battery (17) into the backpack pouch (18).

Step 2. Connect the headphones (16) and the power cable (19) to the appropriate sockets in

the cap of the battery.

Step 3. Put on the backpack (18).

CAUTION – Use only the 6V battery supplied.

Step 4.

Ensure that the power switch on the control box is switched Off before plugging

the power cable connector (19) into the socket on the control

box. This cable connects the battery and headphones to the detector.

1 2 3 4 5 6 7 8 9 10 11 12 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

Minelab GP 3500 Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle Minelab GP 3500