- 5 -
SAFARI DISCRIMINATION TUTORIAL # 1
DISCRIMINATION SCALE – MODIFYING / SAVING
Safari makes it so easy to find exactly what you want and to ignore what
you don’t want. It couldn’t be simpler.
Here’s how:
ACCEPT/REJECT button – this is the key and allows you to adjust the
discrimination pattern to accept or reject any of the 51 segments
shown on the detect screen. This allows you to “build” a custom
discrimination pattern that will ignore unwanted targets and still
get you “the keepers!” When a target is detected, an ID number appears on the left hand side of the screen, an icon
appears on the right hand side and a bar and cursor appear in the Discrimination scale along the bottom of the
screen in a bar graph. The location of the cursor corresponds to the discrimination rating or ID number of the object.
The Target ID Range has 51 numbers from – 10 to + 40
Ferrous objects will have ID’s in the –10 to – 1 range
Non-ferrous objects will have ID’s in the 0 to + 40 range
Objects with highest conductivity will produce the highest numbers and objects with low conductivity characteristics
will produce corresponding low number Target ID’s.
The discrimination pattern of a factory pre-set mode can be modified and saved as a personal setting, so that your
new discrimination pattern can be recalled at any time.
An asterisk icon ❄ will be displayed on the screen to show that a particular mode has been modified.
There are three methods of modifying disc patterns.
Method 1- to reject a specic target/object
1. Wave the coil over the object. The detector will move the cursor to indicate the object’s position on the scale,
and the targets ID number will appear on the screen.
2. Press the ACCEPT/REJECT button to reject the object’s ID.
3. Wave the coil over the target and check it is being rejected. If it still produces a response, reject its new ID by
pressing accept/reject a second time.
Method 2 – to reject a specic Target ID number
1. In the Detect screen use + and – buttons to select the ID you want to modify. The cursor and the Target ID
numbers will indicate the selected ID.
2. Press the ACCEPT/REJECT button to either accept or reject that ID. You will notice the band on the
discrimination scale will become shaded if rejected or clear if accepted. The accept/reject button will toggle
between accepting and rejecting targets.
Method 3 – to accept or reject a large range of Target ID numbers
1. Start from either the first or last number of the ID band you wish to select.
2. Push and hold both the ACCEPT/REJECT button, and the – or + button until the selected area is achieved. You
will note that the cursor box on the Graphic Identification Bar will be shaded when the accept/reject button is
in REJECT mode and clear when in the ACCEPT mode.
Once the discrimination has been modified the ❄ icon will appear next to the mode button to show that the detect
mode has been modified.
Note: These changes to the discrimination pattern will be lost if you change to a different detect mode. So, if you are
always changing modes, be sure to save your changes first. You can always toggle backwards and forwards between
your settings and the factory pre-set settings to check your signals. The modified discrimination pattern can be saved
as a user detect mode by following the next tutorial.
(4 pages)
(74 pages)
(47 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels