Minelab Explorer Spécifications télécharger pdf (Page 5)

6 7

Assembly

Attaching the Coil to the Lower Shaft:

1 Plug the two rubber washers into the

holes on either side of the lower shaft.

2 Feed the coil cable up through the

inside of the lower shaft.

3 Place the coil on a flat surface.

4 Slide the lower shaft into the bracket on

top of the coil. Ensure that the open side

of the lower shaft faces the ground.

Attaching the Lower Shaft to the

Upper Shaft:

1 Fully unlock the upper shaft camlock by

releasing the lever from the shaft.

2 Feed the coil cable up through the

inside of the upper shaft.

3 Ensuring that the camlock side of the

shaft is facing the ground, slide the

upper shaft over the lower shaft, so that

the coil cable appears out the top.

5 Insert the bolt through the lower shaft

and the bracket on top of the coil.

6 Fasten with the nut provided, being

careful not to damage the thread of the

nut by over-tightening. This will need to

be loosened later to adjust the coil to a

comfortable detecting angle.

7 Ensure that the coil cable appears out

the top of the lower shaft.

The coil cable is directly wired into the

coil and is not removable. Any attempt to

remove this cable will void your warranty.

1 2 3 4 5 6 7 8 9 10 ... 43 44

Commentaires sur ces manuels

Pas de commentaire