Minelab E-Trac Manuel d'instructions télécharger pdf (Page 6)

8

9

Attaching the Lower Shaft to the

Upper Shaft:

1 Release the Upper Shaft camlock by pulling

the lever away from the shaft.

2 Feed the coil cable up through the inside

of the Upper Shaft, ensuring the camlock

side of the shaft is facing the ground.

Connecting the Shaft Assembly to the

Handle Assembly:

1 Release the Control Box camlock by pulling

the lever away from the Control Box.

2 Align and push the coil cable connector

into the socket underneath the Control Box,

rmly tightening the retaining ring

to secure.

Assembly

Attaching the Armrest Strap:

1 Clip both buckles onto the outer sides of

the armrest.

Disconnecting the coil:

1 Reverse the steps in ‘Connecting the

Shaft Assembly to the Handle Assembly’,

‘Attaching the Lower Shaft to the Upper

Shaft’ and ‘Attaching the coil to the

Lower Shaft’.

2 Pull the coil cable out from inside the

lower shaft.

Attaching the Headphones:

1 Plug the headphone jack into the

headphone socket, located in the

rubber seal at the battery end of the

Handle Assembly.

The headphones may be plugged or

unplugged at any time.

WARNING: Do not attempt to

completely remove the shaft assembly

while the coil cable is still connected to

the Control Box.

3 Slide the Upper Shaft over the Lower Shaft,

so the coil cable appears out the top.

3 Push the Handle Assembly onto the Upper

Shaft, as far as it will go.

4 Lock the Control Box camlock by pushing

the lever at onto the Control Box.

1 2 3 4 5 6 7 8 9 10 11 ... 48 49

Commentaires sur ces manuels

Pas de commentaire