Minelab GP 3500 Manuel de service télécharger pdf (Page 9)

THE MINELAB ‘GP extreme’

ASSEMBLY

www.minelab.com

COMPLETE ASSEMBLY INSTRUCTIONS

Securing and connecting the coil cable

NOTE Always ensure that the control box is turned off

completely before connecting or disconnecting the coil.

STEP 1 Wind the coil cable around the shaft and plug the coil

connector into the coil socket on the control box. Check that

the cable is wound firmly around the shaft without strain,

leave enough slack at the bottom of the cable near the coil to

allow for adjusting the angle of the coil without placing strain

on the coil cable.

STEP 2 Fasten the cable into position using the Velcro straps

provided (20).

Fitting and connecting the battery pack

Figure 2.6

STEP 1 Fit the battery (17) into the back pack pouch (18).

STEP 2 Connect the headphones (16) and the power cable (19) to

the appropriate sockets in the cap of the battery.

STEP 3 Put on the back pack (18).

If the coil cable is able to move

around, especially near the coil, it

will be

‘seen’ by the detector and

cause random noises which may be

confusing.

HINT

Use only the 6v DC battery supplied

CAUTION

Attaching the lower fibreglass shaft

Figure 2.2

STEP 1 Slide the lower fibreglass shaft (4) into the intermediate shaft (7).

STEP 2 Adjust shaft length and coil angle for a comfortable position.

Minelab recommends that the shaft length be set to give a

comfortable sweep length of approximately 2 meters. The

lower fibreglass shaft can be set into position by locating the

spring clip into the holes provided in the intermediate shaft

and hand tightening the locking nut at the end of the

intermediate shaft.

THE MINELAB ‘GP extreme’

ASSEMBLY

COMPLETE ASSEMBLY INSTRUCTIONS

STEP 4 Ensure that the power switch on the control box is switched

off and plug the connector on the power cable (19) into the

battery connector plug on the control box. This cable

connects the battery and headphones to the detector.

Adjust for your own comfort

STEP 1 Adjust the bungy cord (21) from the knuckle (22) on the shaft

to correct length to take some of the weight when

prospecting.

STEP 2 Adjust the hand strap on the handle (9) for your own comfort.

Figure 2.6 The ‘GP extreme’ battery assembly

P0503-A

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

Commentaires sur ces manuels

Pas de commentaire

Minelab GP 3500 Manuel de service Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle Minelab GP 3500