Minelab X-Terra 505 Manuel d'instructions télécharger pdf (Page 39)

Again, the number of tones you set for your X-TERRA is simply a matter

of personal preference. If you chose single tone, all targets will provide

an audio report at 450 Hz. Regardless of whether you chose two tones,

three tones or four tones, targets with a negative TID (ferrous targets) will

produce an audio report of 130 Hz. With the exception of the single tone

setting, once you get into the positive side of the notch segments, the

pitch of the audio response will increase as the conductivity value of the

target increases.

The tone assigned to each target value will vary by the model of your

detector, due to each model having a dierent number of notch

segments. Therefore, check your Instruction Manual for the specics of

your detector. On a side note... although Minelab display the multiple

tones as 99, there aren’t 99 tones. There is actually one tone for each

notch segment, as shown in the chart on page 38.

Understanding your X-TERRA - Discrimination











 





















1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 95 96

shhshh 23 Jan 2024 | 16:17:44

Minelab X-Terra 505 Manuel d'instructions Page 39