F3 Field Service Manual
Page 13
3. Disassembly & Reassembly Procedures
3.1 Introduction. This section describes the procedures required to exchange line
replaceable units. Whenever a unit is replaced, mechanical and functional testing as
described in Section 2 must be completed.
3.2 F3 Tool Kit. The F3 Tool Kit (Part No 3004-0018) is required to disassemble and
reassemble the F3. The tool kit (Figure 9) comprises:
● Minelab Part No Description
● 0005-0014 Silicon Grease (100g tube)
● 0005-0010 Silicon Sealant (75g tube)
● 8701-0009 Tubular Spanner 7/8”
● 8701-0010 F3 Coil Cable Pull Through
● 8701-0011 Screwdriver Pozidrive No 1
● 8701-0018 Hex Key T Handle 2.5mm
● 8701-0012 Hex Key T Handle 3.0mm
● 8701-0013 Flat blade screwdriver 6.5mm x 150mm
Figure 9: F3 Tool Kit
NOTE
All tools except the F3 Coil Cable Pull Through are commercially available. If necessary, a
length of string can be used as the F3 Coil Cable Pull Through.
3.3 Electronics Pack. Figure 10 illustrates the major parts involved in removing and
replacing the electronics pack. The F3 and F3L use different electronics packs and should
not be interchanged unless the correct speaker pods (F3L requires the speaker pod with
LED display) are also fitted.
Commentaires sur ces manuels