F3 Field Service Manual
Page 19
NOTE
Once a coil pin is fitted to a coil cable, it is not necessary to fit a coil plug retainer.
● Connect the coil cable pull through to the coil plug. (Figure 18)
Figure 18: Coil Pull Through Connected to Coil
NOTE
If a coil pull through is not available a length of string can be used.
● Prior to threading the cable through the shafts, ensure the cable has 52 turns in the
coil cable curly section. (Figure 19)
Figure 19: Coil Cable with 52 Turns
● Slide the coil cable pull through the shafts starting from the lower end until the lower
camlock assembly is resting above the coil. (Figure 20)
Figure 20: Using the Pull Through to Thread Cable Through Shafts
Commentaires sur ces manuels