Minelab Safari Manuel d'instructions télécharger pdf (Page 33)

31

Method 2 –

To reject a specic Target ID number:

1 In the Detect screen use – and + buttons

to select the ID you want to modify. The

cursor and the Target ID numbers will

indicate the selected ID.

2 Press the Accept/Reject button to either

accept or reject that ID. You will notice

the band on the discrimination scale

will become shaded if rejected or clear if

accepted. The Accept/Reject button will

toggle between accepting and rejecting

targets.

Method 3 –

To accept or reject a large range of

Target IDs:

1 Start from either the rst or last number of

the ID band you wish to select.

2 Push and hold both the Accept/Reject

button, and the – or + button until the

selected area is achieved. You will note that

the cursor box on the Graphic Identication

Bar will be shaded when the Accept/Reject

button is in Reject mode and clear when in

the Accept mode.

Tip: The Accept/Reject button is very eective

when in the Low Trash Density setting. The High

setting enhances the detectors ability to pick

out good targets in high concentrations of Iron,

and as a result the Accept/Reject function is not

as accurate. (See p. 28 for more information on

Trash Density)

Once the Discrimination Pattern has been

modied, the icon will appear next to

the Mode button to show that the Detect

Mode has been modied. These changes to

the Discrimination Pattern will be lost if you

select a dierent Detect Mode. The modied

Discrimination Pattern can be saved as a User

Mode by following the steps in To Create and

Save a User Mode (p. 32).

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 43 44

Commentaires sur ces manuels

Pas de commentaire