Minelab Eureka Gold Manuel de service télécharger pdf (Page 20)

Page 36 The Minelab Eureka Gold

12. The Coil and Skidplate

Over a long period of time the Coil Skidplate will wear if the ground is

scrubbed continuously while searching. Minelab agents can supply a

replaceable skidplate for the Coil. This can be fitted by removing the

existing plate and pushing on the replacement skidplate (see Figure 21).

Skidplates are inexpensive and it is recommended that you protect your

coil by regularly replacing the skidplate.

Figure 21 - Skidplate to Protect Coil

Hint: The use of non-metallic tape around the edge of the coil/skidplate will

help to prevent the ingress of dirt or moisture.

P0584-A

Page 37 The Minelab Eureka Gold

13. Environmental Concerns

Firstly, it should be pointed out that gold prospecting and treasure hunting

with a metal detector is the most environmentally friendly way to recover

nuggets, coins, rings, and other treasure items. However, it is important to

leave an area that you have searched in the same condition as you found

it.

All holes that have been dug must be properly refilled. Not only is it

environmentally unacceptable to not fill in your holes, it is also very

dangerous. There are special tools to enable you to recover targets easily

from grassed areas without digging large holes.

Take away and properly dispose of any junk that you find or produce, such

as nails and tin cans. Use a rubbish pouch on a belt to collect the rubbish

while searching and dispose of it environmentally when you return home.

Leaving an area ‘scarred’ can result in action being taken to prevent the

use of metal detectors, which spoils this fascinating hobby for others as

well as yourself.

1 2 ... 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Minelab Eureka Gold Manuel de service Page 20