Minelab Eureka Gold Manuel de service télécharger pdf (Page 5)

Page 6 The Minelab Eureka Gold

3. Assembling the Detector

Please follow these instructions to assemble the Eureka Gold. Refer to

the drawings to identify parts and how they are positioned. Please contact

your Minelab dealer for further instructions should any difficulties arise.

3.1 Armrest/Upper Shaft Assembly

a) Place the two armrest halves (4) on either

side of the upper shaft (2) and ensure that

the bolt hole is aligned.

b) Slide the nylon bolts through the bolt holes

and screw the nylon wing nuts (12) onto

the bolts with a couple of turns (do not

tighten).

c) Slide the detector stand (7) into the

runners of the armrest (4) and tighten the nylon wing nuts by hand.

d) Attach the armrest straps (6) using the press studs on both sides of

the armrest.

e) Push the armrest straps through the slots in the armrest cover (5) and

push the cover over the armrest.

3.2 Lower Shaft Assembly

a) Remove the tape on the lower fibreglass tube

(3) that is holding the black teardrop washers

(10) in place.

Note: Ensure the washers do not fall out after

removing the tape.

b) Remove the black nylon wing nut (12), and

bolt (11) from the coil (9).

Figure 2 - Armrest/Upper

Shaft Assembly

P0570-A

Figure 3 - The Coil and

Lower Shaft Assembly

P0588-A

Page 7 The Minelab Eureka Gold

c) With the teardrop washers in place, push the lower tube (3) into the

coil bracket so that the holes line up.

Note: Ensure that the black nylon spring clip near the top of the fibreglass

tube is pointing toward the rear of the coil.

d) Push the black nylon bolt (11) through the holes in the bracket on the

coil from the cable entry side, put on the spacer (19) and tighten the

wing nut (12) by hand.

3.3 Completing the Shaft Assembly

a) Slide the lower shaft assembly (3) into the Aluminium upper shaft (2).

Note: The black plastic locking nut (18) may need to be loosened to

position the lower shaft assembly correctly.

b) Set the length of the shaft by locking the black nylon spring clip

into one of the holes provided, then tighten the plastic locking nut.

3.4 Shaft Mount

a) Position the control box so that the recess in the control box (1) is aligned

with the leading edge of the mounting clip (8). Push the

forward section of the control box upwards until the trigger ‘clicks’

indicating the control box is secured (see figure 5).

Figure 4 - Completing the Shaft Assembly

P0585-A

1 2 3 4 5 6 7 8 9 10 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Minelab Eureka Gold Manuel de service Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle Minelab Eureka Gold