Minelab Eureka Gold Manuel de service télécharger pdf (Page 7)

Page 10 The Minelab Eureka Gold

Note: Leave enough slack at the bottom of the

cable near the coil to adjust the coil position

without straining the coil cable.

e) Use Velcro

tabs to secure the cable in

position at the base of the shaft and where

the cable leaves the shaft.

f) Take the excess loose coil cable and wind it

through the belt bracket of the hipmount bag

prior to connecting onto the control box

(see figure 8).

g) Connect the coil connector to the socket on the rear of the control box

and tighten the locking nut.

4. Batteries

Your Eureka Gold is supplied with a rechargeable 12 Volt NiMH battery

pack and mains charger. A car charger is also available as an accessory

item from your authorised Minelab Dealer.

4.1 Installation of NiMH Battery Pack

a) Ensure your NiMH pack is fully charged.

b) Place the base of the battery pack at the rear

of the battery compartment (A). Push the front

edge of the battery pack into position (B). The

two battery clips will “click” into position to hold

the battery pack in place (see figure 9).

Note: The NiMH battery pack is factory sealed

and does not open.

Figure 9 - Installing

the Battery Pack

Figure 8 - Hipmounting

the Control Box

P0586-A

Page 11 The Minelab Eureka Gold

4.2 Installation of Alkaline Batteries

A 12 Volt battery pack to hold 8 ‘AA’ alkaline batteries is available as an

accessory item. These are useful to have as back-up if ever your NiMH

batteries are flat.

a) Ensure the detector is switched “Off” before opening the battery

compartment.

b) Slide open the lid on the battery pack.

c) Place 8 “AA” alkaline batteries (16) into the

base of the alkaline pack (15). Ensure they

are aligned as shown in figure 10 and as

indicated inside the compartment.

d) Slide the battery lid closed.

e) Place the base of the battery pack at the rear of the battery

compartment (A). Push the front edge of the battery pack firmly into

position (B). The two battery clips will “click” into position to securely

hold your battery pack in place (see figure 9).

Caution: Good quality alkaline batteries will power the Eureka for about 10

to 15 hours and should always be used instead of standard carbon

batteries. Alkaline batteries should be removed from the detector if it is to

be stored for extended periods to avoid damage caused by leaking batteries.

Using headphones will extend battery life.

Figure 10 - Replacing

the Battery Lid

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Minelab Eureka Gold Manuel de service Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle Minelab Eureka Gold