Minelab Eureka Gold Manuel de service télécharger pdf (Page 6)

Page 8 The Minelab Eureka Gold

c) Connect the coil connector (13) to the plug on the rear of the control

box (14).

d) Use Velcro

tabs to secure cable in the

correct position on the shaft maintaining

slack at coil and control box.

Note: Weather Protection - The hipmount

bag is designed so that it can be used to

weatherproof your control box while detecting in

inclement weather. The new design allows the

hipmount bag to protect the control box while still on the shaft. The

control box is positioned into the hipmount bag with the slot for the

mounting bracket positioned at the back. The velcroed panel is then

wrapped across the top of the stem. The hipmount bag is available from

your supplier as an accessory item.

3.5 Rear Shaft Mount

The Eureka Gold provides the option of mounting

the control box at the rear of the shaft (2),

beneath the armrest.

In order to mount the control box (1) in this

position:

a) Loosen the nylon wing nut from the armrest

and remove the detector stand.

b) Firmly wind between 17 and 20 turns of the cable around the shaft until

it reaches the control box.

Note:

Leave enough slack at the bottom of the cable near the coil to adjust

the coil position without straining the coil cable.

Figure 5 - Mounting the

Control Box on the Shaft

Figure 6 - Mounting the

Control Box to the Rear

of the Shaft

P0573-A

P0572-A

Page 9 The Minelab Eureka Gold

e) Firmly wind the cable up the stem using the Velcro

tabs to hold in

position.

f) Connect the coil connector (13) to the plug (14) on the rear of the control

box.

d) Clip the control box onto the rear mounting bracket (see figure 5).

b) Slide in the black plastic rear control box bracket (8).

c) Tighten the nylon wing nut on the armrest.

3.6 Hipmounting/Chestmount

Hipmounting is an alternative to mounting the detector on the shaft and

significantly reduces physical strain, enabling longer search time without

undue fatigue. A hipmount bag is available as an accessory item

for this purpose.

a) Check that there are charged batteries in the control box.

b) Place the control box into the hipmount bag with its control panel

facing outwards (see figure 7).

c) Place the hipmount bag in your preferred

working configuration. The hipmount bag can

be worn on the belt or over the shoulder.

Note: If mounting the hipmount bag on the chest,

a belt can be thread through the belt loop and

around the chest to hold the bag in position.

d) Wind about 5 turns of the cable around the

shaft. This will reduce the amount of excess

cable.

Figure 7 - Hipmounting

the Control Box

P0582-A

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Minelab Eureka Gold Manuel de service Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Mesure, test et contrôle Minelab Eureka Gold