Minelab F1A4 Manuel de service télécharger pdf (Page 12)

F1A4 Field Service Manual – Level 1 and Level 2 Maintenance

Page 12

3.1.1 Servicing the Upper and Lower Camlocks

5. Assembly is the reverse of the dismantling procedure, with attention to the

following:

1. use only new components from the

appropriate Camlock Service Kit,

2. press the Stainless Steel Wear Plate

firmly into the Pressure Block, and

3. ensure that the correct Pressure Block

is used at the correct end.

Note: The Pressure Block End Views (at right)

should help the identification process.

1. Knock out Camlock Pivot

Pin with the 3 to 3.5mm punch.

2. Remove Cam Lever

from the Camlock Body.

3. Remove Pressure Block

from the Camlock Body.

4. Slide the Camlock Body from the shaft.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 35 36

Pas de commentaire

Minelab F1A4 Manuel de service Page 12