Minelab F1A4 Manuel de service télécharger pdf (Page 27)

F1A4 Field Service Manual – Level 1 and Level 2 Maintenance

Page 27

factory repair facility.

12. Assembly is the reverse of the dismantling process, with attention to the

following:

1. Ensure that the PCB is correctly orientated before fitting into case.

The coil connector and power connector will be nearest the black

mounting block and the power connector at the end with the clips.

2. When reconnecting the ribbon cable, ensure that there are two spare

pins on the loudspeaker side and three spare pins on the earset jack

side. Apply a spot of hot glue to the blue ribbon connector plug to

hold it in place.

3. Refer Section 7 for PCB connections if required.

4. Replace gaskets with new gaskets if required.G

13. Go to Section 4 to retest the F1A4 Control Box.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Pas de commentaire

Minelab F1A4 Manuel de service Page 27