Minelab EXPLORER II Manuel de service télécharger pdf (Page 18)

THE MINELAB EXPLORER II

ASSEMBLY

www.minelab.com

STEP 3 Check the orientation of the search coil and shaft ensuring

that the open side of the yoke faces the ground.

STEP 4 (Figure 2.2) To join the shaft to the search coil, slide the

yoke into the yoke bracket on top of the coil.

STEP 5 (Figure 2.3) Insert yoke bolt through the search coil’s yoke

bracket and the coil yoke. Fasten with the yoke nut

provided, being careful not to damage the thread of the

nut by over-tightening. This may need to be loosened to

adjust the coil to a comfortable detecting angle.

You are now ready to proceed to the shaft assembly.

CONNECTING THE SEARCH COIL

Figure 2.3 Securing yoke to search coil

Figure 2.2 Inserting coil yoke into bracket

P0606-A

P0605-A

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 111 112

Pas de commentaire

Minelab EXPLORER II Manuel de service Page 18