Minelab EXPLORER II Manuel de service télécharger pdf (Page 60)

THE MINELAB EXPLORER II

QUICKSTART

www.minelab.com

AUDIO: ADJUSTING THE SOUNDS

Figure 5.19 Sounds menu

AUDIO: ADJUSTING THE SOUNDS

Introducing Sounds

Figure 5.19

Main Menu > Audio > SOUNDS

The SOUNDS menu allows you to define how the pitch varies with

target characteristics. This can be a very useful feature in

identifying targets in close proximity to one another. It is possible

to instruct the detector to emit a distinct sound responding to an

object’s ferrous characteristics, rather than its conductive

properties. To test sounds upon selection it is necessary to move

the coil across one or more targets with different conductive and

ferrous properties.

Constant

Main Menu > Audio > Sounds > CONST

Selecting CONST eliminates the variation of the pitch upon

detection. If selected, the Explorer II will emit a consistent tone

regardless of the target detected.

Conductivity

Main Menu > Audio > Sounds > CONDUCT

Conduct is the factory preset and Minelab’s recommended option.

Selecting CONDUCT adjusts the tone to identify the object relative

to its conductivity (the vertical axis of the Smartfind screen).

A high pitched tone denotes a large, highly conductive object with

target crosshair displayed near the top of the Smartfind screen

(or near a Digital rating of 32).

A low pitched tone denotes a small object with low conductivity.

The target crosshair is displayed near the bottom of the Smartfind

screen (or near a Digital rating of 1).

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 111 112

Pas de commentaire

Minelab EXPLORER II Manuel de service Page 60