Minelab EXPLORER II Manuel de service télécharger pdf (Page 30)

THE MINELAB EXPLORER II

BATTERIES

www.minelab.com

Minelab’s battery chargers are

suitable for the Explorer NiMH

battery pack only. The battery

chargers will not recharge

rechargeable alkaline batteries.

Using a non-Minelab charger with

the battery pack may damage it

and will void the product

warranty.

Recharging

THE BATTERY PACK

Recharging NiMH battery pack with the car charger

A car charger for the NiMH battery pack is available for the

Explorer II.

STEP 1 Remove battery pack as per instructions on page 24.

STEP 2 Insert the car charger plug into the cigarette lighter socket.

STEP 3 Insert the car charger plug into the socket at the tapered end

of the battery pack. A small light on the car charger

illuminates indicating that the car charger is in operation.

NOTE Some vehicles will need the ignition to be switched on

to ‘accessories’ for power to be supplied to the charger.

STEP 4 Leave the battery to charge for about 18 hours for a

complete recharge. If the battery was not completely

discharged, the charging time will be shorter.

The car charger is provided with a 3AG 2Amp fast fuse for short

circuit protection that can be accessed by unscrewing the tip of

the cigarette lighter plug.

NOTE Charging the battery beyond full capacity will not

damage the NiMH battery pack, but it could gradually

discharge your car battery.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 111 112

Pas de commentaire

Minelab EXPLORER II Manuel de service Page 30