Minelab EXPLORER II Manuel de service télécharger pdf (Page 26)

THE MINELAB EXPLORER II

ASSEMBLY

www.minelab.com

STEP 4 (Figure 2.15) Gently pull the coil cable from inside the

yoke/lower shaft.

STEP 5 (Figure 2.16). Carefully feed the coil cable of the new coil

back into yoke and lower shaft. Continue to feed the cable

into the shaft unitl the connector is visible at the top of the

shaft.

NOTE : It may be easier to pull the cable through the

lower shaft using a length of string or cord. Once this is

completed you should be able to see approximately 4

inches (100mm) of cable between the coil yoke and the

search coil. This is the slack necessary to allow

adjustment to the angle of the search coil.

STEP 6 Re-attach the yoke and the search coil. Be careful not to

damage the thread of the nut by over-tightening. See

Figure 2.2 and 2.3.

STEP 7 Reconnect cable to control box (as directed in

Connecting the shaft assembly, page 16).

REPLACING AND FITTING THE SEARCH COIL

Figure 2.16 Removing the coil cable

Pull Coil Cable

up inside of

yoke/shaft

P0613-A

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 111 112

Pas de commentaire

Minelab EXPLORER II Manuel de service Page 26